Linde Polymer Tec Co.,Ltd. is one of the most experienced manufacturers and suppliers of o-ring splicing kit in China, also supports customized service. Please feel free to buy high quality o-ring splicing kit for sale here from our factory.
O-Ring Splicing Kit
| Material | EPDM |
| Density | 1.20~1.30g/cm³ |
| Hardness | 30-60 Shore A |
| Tensile strength | 5~20MPa |
Introduction
An O-ring splicing kit is valuable for making custom-sized O-rings for immediate repair in the field.
As with all spliced O-rings, they are suitable for static applications. Field-spliced O-rings can be used as a temporary sealing solution.
Advantages
1. High flexibility: By using O-ring splicing kits, we can flexibly manufacture O-rings of different sizes and materials according to actual needs to meet various sealing needs.
2. Good sealing performance: Since the splicing clamp and fast-curing adhesive in the kit can ensure that the spliced O-ring is tight and firm, its sealing performance is well guaranteed.
3. Easy to operate: The step-by-step instruction card in the kit provides clear steps and operating guidelines, making the splicing process simple and easy.
4. Economical and affordable: Compared with purchasing a single complete O-ring, using a splicing kit can save costs, especially when frequent replacement of O-rings of different sizes is required.
5. Strong adaptability: Whether it is on-site maintenance or other occasions that require flexible sealing solutions, the O-ring splicing kit can exert excellent performance.
How to Splice O-Rings
To begin assembling the O-ring, use the following instructions as a guide:
1. Wrap the wire into the space where the final O-ring will sit. Mark an additional mark on the wire 0.5 inch after the initial letter. Alternatively, if you know the O-ring diameter, multiply that value by 3.14 to retrieve the cutting length required for the initial mark (and a secondary mark 0.5 inches after the initial mark).
2. Pass the wires through the corresponding circular cross-section holes on the splicing fixture, aligning the auxiliary marks with the fixture opening.
3. Use the blade to cut through the middle of the clamp. The distance between the clamp opening and the middle is 0.5 inches, which is why auxiliary marks are placed on the rope for guidance.
4. Apply adhesive to only one end surface. Less than one drop is enough. NOTE: Adding too much adhesive will weaken the bond.
5. Using the grooved side of the splicing jig, slide the treated wire ends into the corresponding cross-section grooves. Then carefully slide the untreated end from the other side of the groove until the ends meet.
6. Press gently with your fingers and hold this position for 30 seconds. Do not twist the power cord.
7. Upon completion, the spliced O-rings should be available for repair.
Hot Tags: o-ring splicing kit, China o-ring splicing kit manufacturers, suppliers, factory, Rubber O Ring Kit, O Ring Splicing Kit, Automotive Air Conditioning O Rings, O Ring Kit Nitrile, Oxygen Regulator O Ring Kit, Vacuum Pump O Ring Seal Kits
